When the fault needs eyes on the machine
We come directly to your installation for line-down emergencies, cabinet-level diagnostics, and firmware or parameter work that remote support can't finish.
Photos of the cabinet and error codes get you scheduled fasterDiagnostics where the fault actually lives
- Emergency troubleshooting for drives, PLCs and HMIs
- Cabinet-level diagnostics: wiring, I/O, power and communications
- Parameter backup, migration and firmware compatibility checks
- A clear technical report with next-step recommendations
Local presence, controlled response times
Typical response time, depending on severity and availability.
Short travel distances keep both response time and cost under control.
On-field work pairs with workshop repair or replacement supply when needed.
Some faults only show up in the real installation
Load, wiring, or cabinet conditions that a bench test can't reproduce are often the actual cause. On-site diagnostics finds the root cause faster and prevents parts being swapped that were never the problem.
- Line down due to a drive or PLC failure
- Intermittent faults and sporadic stops
- Start-up support after a retrofit or upgrade
- Parameter migration between firmware versions
Three steps from call to closed case
Request & triage
Tell us what's down, what changed, and what alarms you're seeing. We confirm scope and the fastest next step.
Scheduling & prep
We agree a time window and a short prep checklist — access, safety, documentation, spares.
On-site intervention
We diagnose, act, and leave you with a clear report and a plan: workaround, repair, or replacement.
Cabinet, parameters, and everything between
Control cabinet
- Power rails, grounding and noise
- I/O integrity, wiring, connectors, sensors
- Drive feedback loops and safety-chain checks
- Fieldbus / Ethernet communication and addressing
Parameters & firmware
- Parameter backup, restore and migration
- Firmware version and hardware compatibility
- Start-up support after retrofit or upgrade
- A concrete repair vs. replace vs. retrofit plan
Get us ready before the visit
Send us this first
- Photos of labels, the cabinet, and affected modules
- Error codes or alarms, and when they happen
- Part numbers, variants and firmware versions if known
- Any recent changes — retrofit, rewiring, new sensor or PLC program
- A short description of the work you need
- Whether anyone already tried to repair it
On the day
- Safe access to the cabinet or machine, plus any required permits
- A point of contact on-site (maintenance or automation)
- Documentation — schematics, manuals, network topology
- Spare candidates on hand, if you have them
We work on the electronics only. Mechanical work on motors, pumps or hydraulic and pneumatic parts is done by your team or your mechanical contractor. Read the on-site conditions.
Ready to get someone on site?
The clearer the details up front, the faster we can schedule and arrive prepared.